Supporti per cuscinetti024SNL3136
SUPPORTO SKF SNL 3136
Supporti per cuscinetti
Description
SNL plummer (pillow) block housings in the 30, 31 and 32 series are robust and suitable for tough operating conditions. They enable the incorporated bearings to achieve maximum service life with less need for maintenance. Different housing variants and seal designs are available, making the use of tailored housings virtually unnecessary and enabling cost-effective bearing arrangements to be made.
- Easy to install
- Cost-effective bearing arrangement
- Reduce maintenance
- Minimize lubricant leakage
Key data
Supporti per cuscinetti- Centre height (pillow block)
- 180mm
- Centre distance between bolt holes (axial direction)
- 110mm
- Breaking load at 0° load angle (if the housing is not supported over its entire base)
- 1,900kN
- Breaking load at 120° load angle
- 850kN
- Breaking load at 150° load angle
- 760kN
- Breaking load at 180° load angle
- 950kN
Item details
- Item
- 024SNL3136
- Category
- A.08
- Unit of measure
- PZ
Technical specifications
34 specifications · highlighted (yellow border): used as catalog filters
| Centre height (pillow block) | 180mm |
|---|---|
| Centre distance between bolt holes | 450 |
| Attachment bolt diameter | 24 |
| Overall length | 530 |
| Overall height | 352 |
| Recommended diameter of attachment bolts | 24 |
| Foot width | 190 |
| Centre height of bearing seat | 180 |
| Diameter of bearing seat | 300 |
| Centre distance between bolt holes (axial direction) | 110mm |
| Recommended tightening torque for attachment bolts | 665 |
|---|
| Housing type | Pillow block |
|---|---|
| Material, housing | Cast iron |
| Number of bolt holes for fasteners | 4 |
| Bearing housing seal type | Without |
| Initial grease fill, 40% | 1.4 |
| Initial grease fill, 20% | 0.9 |
| Corrosion protection | Paint - in accordance with ISO 12944-2, corrosivity category C2 |
| Thread of relubrication holes | 1/8-27 NPSF |
| Housing lubrication feature/possibility | Grease |
| Mounting arrangement | Through shaft/Shaft end |
| Housing configuration | Two-piece |
| Breaking load at 0° load angle (if the housing is not supported over its entire base) | 1,900kN |
| Breaking load at 120° load angle | 850kN |
| Breaking load at 150° load angle | 760kN |
| Breaking load at 180° load angle | 950kN |
| Breaking load at 55° load angle | 2,400kN |
| Breaking load at 90° load angle | 1,150kN |
| Breaking load, axial | 620kN |
| Load to reach yield point at 120° load angle | 1,800kN |
| Load to reach yield point at 150° load angle | 1,040kN |
| Load to reach yield point at 180° load angle | 900kN |
| UNSPSC code | 31171519 |
|---|---|
| EClass code | 23-05-17-01 |