Unità cuscinetto a sfere021UCP212
SUPPORTO SKF UCP 212/H
Unità cuscinetto a sfere
Description
Pillow (plummer) block ball bearing units consist of an insert bearing mounted in a cast iron housing that can be bolted to a support surface. This variant is strong and stiff, and is suitable for applications with both constant and alternating directions of rotation. It has an inner ring extended on both sides and is locked onto the shaft by tightening a set screw on the inner ring, making it easy to mount.
- Strong
- Designed for a constant and alternating rotation
- Ready to mount
- Lubricated and sealed bearing
- Quick locking onto the shaft
- Cost-effective
Key data
Unità cuscinetto a sfere- Shaft diameter
- 60mm
- Centre height (pillow block)
- 69.8mm
- Basic dynamic load rating
- 52.7kN
- Fatigue load limit
- 1.53kN
- Shoulder diameter inner ring ≈
- 75.64mm
- Limiting speed
- 2,700r/min
Item details
- Item
- 021UCP212
- Category
- A.08
- Unit of measure
- PZ
Technical specifications
47 specifications · highlighted (yellow border): used as catalog filters
| Shaft diameter | 60mm |
|---|---|
| Centre height (pillow block) | 69.8mm |
| Centre distance between bolt holes | 184 |
| Attachment bolt diameter | 16 |
| Housing overall width | 62 |
| Shoulder diameter inner ring ≈ | 75.64mm |
| Width of inner ring | 65.1mm |
| Recommended diameter for attachment bolts, inch | 0.625 |
| Recommended diameter for attachment bolts, mm | 16 |
| Hexagonal key size for set screw | 5 |
| Distance from locking device side face to raceway centre | 39.7 |
| Diameter of attachment bolt hole | 20 |
| Overall length | 239.5 |
| Distance from locking device side face to thread centre | 10 |
| Bore diameter | 60 |
| Bearing width, total | 65.1 |
| Hexagonal key size for the grease fitting | 11.11 |
| Diameter of head sphere of grease fitting | 6.589 |
| Base width | 62 |
| Basic dynamic load rating | 52.7kN |
|---|---|
| Fatigue load limit | 1.53kN |
| Limiting speed | 2,700r/min |
| Basic static load rating | 36kN |
| Recommended tightening torque for set screw | 16.5 |
| Housing type | Pillow block, normal base |
|---|---|
| Material, housing | Cast iron |
| Number of bolt holes for fasteners | 2 |
| Retaining feature, inner ring | Set screws |
| Sealing, unit | Without |
| Grease fitting | With |
| Unit system | Metric |
| Lubricant | Grease |
| Coating | Without |
| Material, bearing | Bearing steel |
| Bore type | Cylindrical |
| Sealing type | Contact, standard |
| Rubber seating ring | Without |
| Note | Limiting speed with shaft tolerance h6 |
| Set screw | M10x1 |
| Sealing type, bearing | Contact, standard |
| Purpose specific | For material handling applications |
| Relubrication hole | With |
| Sealing, bearing | Seal and flinger on both sides |
| Fastening bolt hole type | Plain |
| Thread of grease fitting | 1/8-27 NPT |
| Axial position of the housing thread | 4 |
| Compliance with standard | JIS |
|---|